Installation Steps:
----------------------------
Please follow these steps to install eTDS Ver 1.0 software
(i) The System Partition of the Operating System should be in C:\only.
(ii)Make the Regional Settings for the Date as dd/mm/yyyy inthe short
date format.
Step 1:
(i) Create a folder named DOSETDS under C: drive
(ii) Go to the DOSETDS directiroy by typing in the command as follows
c:\>cd DOSETDS
(iii)Insert the "Installation Diskette" into your floppy drive and copy the
contents of the floppy by typing in the command as follows:
c:\>DOSETDS>COPY A:\*.*<Enter>
(iv) This procedure installs the necessary files on your disk under DOSETDS
directory.
(v) The files contains one ARJ file named instal.arj file & Arj.exe file
( this file is given to extract the instal.arj file ). Extract the file
within the DOSETDS directory by typing in the command as follows:
c:\DOSETDS>ARJ X denain.ARJ<Enter>
Step 2:
(i) Modify your CONFIG.SYS file to incorporate the entries given below. If
you already have the entries, modify them as follows:
FILES = 150
BUFFERS = 30
Step 3:
Modify your AUTOEXEC.BAT file to incorporate the entries given below. if you already have the entries given below. If you already have the entries, modify them as follows:
SET CLIPPER = F150
Step 4:
Reboot your computer, after removing all floppy diskettes from your drive(s).